[sdiy] Moog Source encoder issue

[Julien Delgoulet]

May be replacing the 400* chips that decode the encoder.

Le 12 sept. 2012 à 23:31, Analog/DIY <itsfatmike at gmail.com> a écrit :

> Hi Travis, there was a service bulletin regarding the 5v regulator legs being "dirty" causing things to freeze up, it might not be what is causing your freezes, but it's worth a shot.
> 
> - mike
> 
> Sent from my iPad
> 
> On Sep 12, 2012, at 4:33 PM, Travis Thatcher <recompas at gmail.com> wrote:
> 
>> My friend's Moog Source has a weird problem. It works fine (apart from
>> 2 membrane buttons) for a while, but once it warms up the encoder
>> doesn't respond as it should. It often just gets stuck going in one
>> direction no mater which way you spin it. If i turn it off for like 5
>> minutes it goes back to normal for a bit, then heats up and gets weird
>> again.  I'm thinking a bad cap somewhere? Anyone experience this before?
>> 
>> -- 
>> http://www.travisthatcher.com
>> http://www.soundcloud.com/travisthatcher
>> http://voiceofsaturn.blogspot.com
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy