[sdiy] Korg VC-10

[Bob Weigel]

On 5/20/2012 2:08 PM, Ullrich Peter wrote:
> Hi Paul!
>
> The D3 ist just broken? So you have all parts?
> then it would be possible to glue it with a good two component glue like the UHU endfest 300
> http://www.uhu-profishop.de/en/2-Component-adhesives
> I did the same with a key on my Yamaha AN1x and it nearly can't be seen and is rock solid.
>
> Otherwise the keys should be the same as on the MS10 and MS20 but maybe also hard to get these days...
>
> Ciao
> Peter
>
> http://www.ullrich.at.tt
>
>
> _
THe plastics used in these keys ...you can normally just carefully heat things and melt them back together.  I'll use super glue to temporarily hold them together then avoid the vapors when I melt it of course. Nasty stuff.  In general though I have the keys if it's too bad of a break.