[sdiy] Fwd: Prophet 600 tuning question

[dan snazelle]

neat


are there any other secret key press modes??

thanks

On Mar 1, 2012, at 2:26 PM, g m montalbano wrote:

> ---------- Forwarded message ----------
> From: g m montalbano <montalbanogm at gmail.com>
> Date: Thu, Mar 1, 2012 at 10:26 AM
> Subject: Re: [sdiy] Prophet 600 tuning question
> To: Tom Wiltshire <tom at electricdruid.net>
> 
> 
> The pitch bend calibration is something that's stored in RAM on this
> synth -- calibration can be lost when memory is corrupted, battery is
> changed, etc.
> The procedure for calibrating the pitch wheel is to press Record + 3,
> then rotate the wheel up & down.
> If this DOESN'T work, then you have problems .... but it usually works.
> 
> ~GMM
> 

neat


are there any other secret key press modes??

thanks








> On Sun, Feb 26, 2012 at 7:54 AM, Tom Wiltshire <tom at electricdruid.net>
> wrote:
>> 
>> One other thought - might the pitch bender have gone wonky?
>> If the pitch bend were applying a slight downwards bend, that'd give the
>> effect you're seeing.
>> 
>> T.
>> 
>> On 26 Feb 2012, at 02:18, luther rochester wrote:
>> 
>>> When my 600 tunes up, all 6 voices are in tune with each other and
>>> scaled fine over octaves. But all notes on the synth are a bit flat. I have
>>> to keep the Master Tune knob at about +3 in order for it in tune to properly
>>> to other instruments.
>>> 
>>> I've read the scaling procedure and it seems relatively painless, but it
>>> also doesn't seem like it would address this problem. Is there some other
>>> kind of offset adjustment I can make so keeping the Master Tune at 0 will
>>> mean the synth will be in tune?
>>> 
>>> Thanks
>>> --
>>> ./luther
>>> _______________________________________________
>>> Synth-diy mailing list
>>> Synth-diy at dropmix.xs4all.nl
>>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>> 
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>