[sdiy] panel + vertical pcb mount components

ASSI Stromeko at nexgo.de
Tue Jun 5 20:46:40 CEST 2012


On Tuesday 05 June 2012, 09:44:37, Florian Anwander wrote:
> Looking at that picture arises the question: If you develop such a
> sandwich construction, then all switches sockets potentiometers have to
> have the same mounting hight.

Looking at that picture tells you that they don't. The potentiometers are in 
fact not mounted on the PCB, but "floating" on some spacer and if you look 
closely you'll see that the phenolic of potentiometers is actually quite 
strained since they were apparently soldered in before being fastened to the 
panel.  If you want this to work, you should be mounting all switches and 
potentiometers to a scaffold, then fitting the pins through the PCB, fixing 
the PCB to the scaffold too and then solder all through-hole components.


Regards,
Achim.
-- 
+<[Q+ Matrix-12 WAVE#46+305 Neuron microQkb Andromeda XTk Blofeld]>+

SD adaptation for Waldorf rackAttack V1.04R1:
http://Synth.Stromeko.net/Downloads.html#WaldorfSDada




More information about the Synth-diy mailing list