[sdiy] Eurorack panels DIY

[Ullrich Peter]

Here are my examples:

http://synth.net/m/photos/view/Gorf-housing-by-Synpro 
http://synth.net/m/photos/view/Gorf-housing-by-Synpro-2011-02-08 
http://synth.net/m/photos/view/Gorf-housing-by-Synpro-2011-02-08-0 

Ciao
Peter

-----Ursprüngliche Nachricht-----
Von: synth-diy-bounces at dropmix.xs4all.nl [mailto:synth-diy-bounces at dropmix.xs4all.nl] Im Auftrag von Louis van Dompselaar
Gesendet: Mittwoch, 25. Jänner 2012 16:48
An: sdiy diy
Betreff: Re: [sdiy] Eurorack panels DIY

Which is more or less what I do, for the entire panel.
Although I use a normal laminator and then spray glue on the back and put on the (pre-drilled) panel.
Then cut out the holes from the laminated paper.

Would look good too if only I could cut out panels in regular sizes ;-)

http://casia.org/modular/img/casia_ms01_080730.jpg


Op 25 jan. 2012, om 16:39 heeft Ullrich Peter het volgende geschreven:
> Another method is printing on normal paper and use hot laminating on a sticky foil and glueing this to the alu panel.

_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy

The information contained in this e-mail message is privileged and
confidential and is for the exclusive use of the addressee. The person
who receives this message and who is not the addressee, one of his
employees or an agent entitled to hand it over to the addressee, is
informed that he may not use, disclose or reproduce the contents
thereof, and is kindly asked to notify the sender and delete the e-mail
immediately.