[sdiy] Eurorack panels DIY

[Louis van Dompselaar]

Which is more or less what I do, for the entire panel.
Although I use a normal laminator and then spray glue on the back and put on the (pre-drilled) panel.
Then cut out the holes from the laminated paper.

Would look good too if only I could cut out panels in regular sizes ;-)

http://casia.org/modular/img/casia_ms01_080730.jpg


Op 25 jan. 2012, om 16:39 heeft Ullrich Peter het volgende geschreven:
> Another method is printing on normal paper and use hot laminating on a sticky foil and glueing this to the alu panel.