[sdiy] two VCOs on 1 PCB - problems

Ian Fritz ijfritz at comcast.net
Fri Dec 28 03:29:35 CET 2012


At 07:10 PM 12/27/2012, neil harper wrote:
>how do you do separate grounds for each VCO in the pcb software? do you
>create separate grounds in the schematic for each VCO and then do
>different ground planes for each?

I guess that depends on the software, so an expert with whatever program 
you are using could probably help you do this.  Myself, I usually don't use 
ground planes on a pcb, just carefully routed, thick PS traces.

Ian  




More information about the Synth-diy mailing list