[sdiy] Akai S612 PSU component ID

[Paul Perry]

I think it IS a jumper - I have had ones that looked similar (cream with one 
black band) - but when a power supply fails, the obviously cooked components 
aren't usually the ones that caused the problem in the first place.

Another possibility is that it is a (or was!) a low value inductance.
I've seen ones that looked like your mystery component.

Incidentally, if you are trying to fix a power supply, wear goggles -  PSU 
components often explode when unhappy.

paul perry Melbourne Australia
.
----- Original Message ----- 
From: "Adam Inglis" Subject: [sdiy] Akai S612 PSU component ID


> My old sampler just went phttt.
> On the PSU is a burnt out component that looks like a resistor, marked
> on the PCB as "JW".
> Similar components crossing "JW" connections look like resistors,
> however there is only a single green stripe on the brown body.
> Anyone know what these are? Some kind of fusible resistor?
> I would've thought "JW" meant jumper wire, but apparently not.
>
> Can't find a service manual or schematic on the net.
>
> cheers
> Adam