[sdiy] Thermal clips for ARP TO-92 transistor pairs..

[Harry Bissell]

It also looks like you might use a single fuse clip 
intended for a 3AG fuse (1/4" diameter). Keystone makes these
with a 'rivet' mount. I think they would fit most TO-92 pairs

H^) harry

----- Original Message -----
From: Jean-Pierre Desrochers <jpdesroc at oricom.ca>
To: synth-diy at dropmix.xs4all.nl
Sent: Wed, 04 Apr 2012 10:45:19 -0400 (EDT)
Subject: Re: [sdiy] Thermal clips for ARP TO-92 transistor pairs..


I think I found a solution...
A small adjusted size heat shrink tube
surrounding both TO-92 would do...
JP

 On Wed 04/04/12 11:32 , Jean-Pierre Desrochers jpdesroc at oricom.ca sent:
> 
> Does anybody know a place who supply
> the same thermal metal clips that keeps
> selected TO-92 transistors pairs stuck together in ARP modules ? 
> I'm pretty sure they were done exclusively
> by ARP assembly departments but.... ???
> 
> I'm thinking of using 2possible solution:
> - Tie-wrap around 2 facing transistors
> OR
> - Putting 2 facing transistors and winding
> them with #24 solid wire for a couple of turns
> then gluing the windings with epoxy..
> 
> The clips would be so easier..
> JP
> 
> 
> _______________________________________________
> Synth-diy mailing list
> S
> ynth-diy at dropmix.xs4all.nlhttp://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> 
> 
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy

-- 
Harry Bissell & Nora Abdullah 4eva