[sdiy] PIC freakout?

[Karl Ekdahl]

Just measured all pins, nothing's connected to GND or V+ (except those that should). I guess it's possible that one of my peripheral ICs has gone bad and is outputting something??

Karl
________________________________
Från: Eric Brombaugh <ebrombaugh1 at cox.net>
Till: synth-diy at dropmix.xs4all.nl 
Skickat: tisdag, 22 november 2011 12:15
Ämne: Re: [sdiy] PIC freakout?

On 11/22/2011 10:08 AM, Karl Ekdahl wrote:
> Hey list
>
> So this pic that i've been using for a few months, with the same code, all of the sudden started freaking out and spitting out garbage after about 1-2 seconds of being on and i have no idea why. I've tried several new pics with the same code, i've even tried minimizing the code (even though it worked just fine before and i didn't change it) to just have some test-stuff left but to no avail. I feel like not all the PICs i tried could have been blown (as it must have happened as soon as i put them in the socket in that case) and since they still program that's a good testament to that too. I've checked the power-lines and they seem fine. I'm using the internal oscillator so no faults there.
>
> Any ideas? Could it be something with the powerlines even tho they look just fine on the scope? I tried hooking up a big cap to stabilize any unwanted oscillations but no change.

Any changes in the I/O loading? I've seen odd stuff when there's 
contention on the GPIO logic levels (ie PIC tries to drive a '1' into a 
grounded pin, etc).

Eric
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy