[sdiy] korg monotron and connection to electret mic input

[aankrom]

I have some 5dB pad adapters (inconveniently RCA to 1/8"). Still, they 
might work. I think I have some inline 1/" females somewhere...

On Mon, 21 Nov 2011 08:36:08 -0500 (EST), Harry Bissell wrote:
> I think the only thing you might need to do is to make an attenuator
> in the cable from the monotron to the mAudio, I usually use about a
> 10:1
> divider  (like 10K in series and 1K to ground).  Electret input
> usually have very high gain, too easy to overdrive. Attenuation would
> help that.
>
> H^) harry
>
> ----- Original Message -----
> From: aankrom <aankrom at bluemarble.net>
> To: synth-diy at dropmix.xs4all.nl
> Sent: Sun, 20 Nov 2011 14:59:42 -0500 (EST)
> Subject: [sdiy] korg monotron and connection to electret mic input
>
> I have an mAudio Microtracker II and I wanted to connect my Korg
> monotron directly to its electret mic inputs. I was wondering if that
> 470 Ohm resistor would cause problems given to 5V bias on the inputs.
> Past that there's a capacitor, but I wondered if I should put a
> capacitor in the signal path just to be on the safe side?
>
> AA
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy