[sdiy] korg monotron and connection to electret mic input

[Harry Bissell]

I think the only thing you might need to do is to make an attenuator in the cable from the monotron to the mAudio, I usually use about a 10:1
divider  (like 10K in series and 1K to ground).  Electret input usually have very high gain, too easy to overdrive. Attenuation would help that.

H^) harry

----- Original Message -----
From: aankrom <aankrom at bluemarble.net>
To: synth-diy at dropmix.xs4all.nl
Sent: Sun, 20 Nov 2011 14:59:42 -0500 (EST)
Subject: [sdiy] korg monotron and connection to electret mic input

I have an mAudio Microtracker II and I wanted to connect my Korg 
monotron directly to its electret mic inputs. I was wondering if that 
470 Ohm resistor would cause problems given to 5V bias on the inputs. 
Past that there's a capacitor, but I wondered if I should put a 
capacitor in the signal path just to be on the safe side?

AA
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy

-- 
Harry Bissell & Nora Abdullah 4eva