[sdiy] Permanent protoboard

[Dave Manley]

*Phenolic* PCB?  FR-2? I thought that was a thing long gone.

I like the last line of the description: "Picture shows top and
bottom surface of the board, sold individually."  How do they
sell the top and bottom surfaces individually????

-Dave

P.S. These look reasonable for not much more at $4.95:

http://www.jameco.com/webapp/wcs/stores/servlet/Product_10001_null_2131186_-1


On 6/30/2011 7:29 PM, David Moylan wrote:
> Weird. I was just wondering why I couldn't find a protoboard in this rough form factor. I agree power busses down the middle would make sense, but just having 4 pads left after IC insertion is a huge
> improvement over 3 pad per hole normally.
>
> Dave
>
>
> On 6/30/11 4:20 PM, BrightBoy wrote:
>>> Someone here was lamenting about not having an inexpensive supply of
>>> this stuff a while back:
>>>
>>> http://www.goldmine-elec-products.com/prodinfo.asp?number=G18426
>>>
>>> $3/ea seems pretty reasonable. Certainly gets around a lot of the
>>> downsides of the solderless variety.
>>
>> Those would be nicer if they had a third power (ground) bus running
>> down the middle of the board.
>>
>> Cheers,
>>
>> Jeff
>>
>>
>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
>