[sdiy] trying to control CV sequencer with DAW

[Stewart Pye]

It should work if you are giving it decent 24ppq pulses, as 96 ticks per 
bar is 24ppq.
Have you checked that shuffle is not on ? !

I had problems syncing a TR606  to my Frostwave MIDI-CV many years ago. 
I built a DIY  Midi  to Sync circuit and it worked fine.  Perhaps the 
pulses from the Frostwave unit  were of borderline level and this is 
perhaps the problem you have too. Can you check them on a CRO.

Regards,
Stewart.


dan snazelle wrote:
> Recently I purchased an MFB seq-02 step sequencer for my modular
>
> it has a clock in input which can take 96 or 16 ppqn
>
> I have a PAIA midi2cv converter which has a DIN SYNC mode and a drum mode
> I am using LOGIC
>
>
> My question is whether anyone has any experience or can offer advice on how to SYNC this sequencer or ANY CV sequencer  to the tempo of a DAW sequencer. My sequencer can send out MIDI CLOCK info
> and I tried using the DIN SYNC  DIN 24 ppq 1mS pulses from output 8 on the PAIA midi2cv but this resulted in strange jerky tempo
>
> there is also a DRUM MODE on the PAIA which says:
>
> this mode provides for control of devices that use variable amplitude pulses for triggering, such as analog drum circuits. Each output corresponds to a key and the each key activation produces a 5ms pulse with amplitude proportional to velocity
>
>
>
> I was also wondering if there was some OTHER way to make the appropriate pulses...possibly manually? could i just find a recording of a good PULSE and put it at the appropriate (which would be?) points in the beat?
>
>
> I assume that the Sequencer is looking for the edge of a pulse. 
>
>
> thanks for any advice and any advice in general on clocking sequencers to DAW/MIDI
>
>
> thanks!
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>