[sdiy] PIC advice needed (OT)

[Harry Bissell]

I'm using the 18F23K22 to make a bridge between SPI (slave) and I2C (slave). This one has two MSSP units for me to play with.

I'm making a programming header and I have connections to VPP/MCLR (1), PGD (4), PGC (5), and GND (3).  I see some designs that also have a "PGM" pin (6)
on the header as well, but the device does not have a PGM pin...

Thanks for all the help so far. Marc's schematic was a big help !

H^) harry


----- Original Message -----
From: Eric Brombaugh <ebrombaugh1 at cox.net>
To: synth-diy at dropmix.xs4all.nl
Sent: Tue, 18 Jan 2011 11:05:36 -0500 (EST)
Subject: Re: [sdiy] PIC advice needed (OT)

On 01/18/2011 07:48 AM, Harry Bissell wrote:
> Hi All...
>
> I need to get some help with a PIC design. Maybe someone here has some insight.
>
> I need a reference design for a PIC18F series chip. I'm looking for what glue might be needed, programming header, thongs like that.
>
> What tools are available for free, for cheap, and for $$$ (but fast to get up on) ?
>
> I have an MPLAB ICD2 at my disposal
>
> Don't ask what I'm doing, if I knew I'd be bragging instead of begging :^)

If you've got an ICD2 already then the only other thing you really need 
is Microchip's free MPLAB IDE - download it direct from them here:

http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1406&dDocName=en019469&part=SW007002

Lots of documentation, support forums, etc at that site as well...

Eric
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy

-- 
Harry Bissell & Nora Abdullah 4eva