[sdiy] Music Easel PCB adaptation project NYE special

[Lanterman, Aaron]

Most of you are probably familiar with my little side project of adapting circuits from the Buchla Music Easel (technically the 208) to act as stand-alone modules. The docs are here:

http://users.ece.gatech.edu/~lanterma/buchla/boards/boards.html

I have each board in, except for the Balanced Modulator. Prices are as follows:

Preamp/Envelope Detector: $10
Lowpass Gate: $15 (interesting in that the mode, i.e. lowpass, vca, or "both", can be selected via voltage control)
Pulser: $16
Envelope Generator: $22 (interesting in that *every* stage can be voltage controlled)
Timbre & Crossfade: $24

These are all Revision 1 boards.

Last year on NYE I ran a little special which was fun, so let's do it again: normally it's $5 S&H to the US and $7 S&H for outside the US. But if you paypal me the appropriate amount by midnight, I'll waive S&H. S&H free until 2012. ;)

My paypal is lanterma at ece.gatech.edu. For general correspondence about the boards, please use abovenyquist at gmail.com (so I can consolidate it in one spot). 

- Aaron