[sdiy] FPGA Based Modules...

[James Elliott]

Sorry, that was supposed to go to Scott, off-line!



----- Original Message ----
From: James Elliott <johans121 at yahoo.com>
To: synth-diy at dropmix.xs4all.nl
Sent: Fri, April 29, 2011 6:54:21 PM
Subject: Re: [sdiy] FPGA Based Modules...

Scott, I just wanted to write you a quick email to thank you for the information 

you sent my way. I'm sorry for the delay in doing this, I just haven't had a lot 

of time to do so as the semester is wrapping up and I haven't had a chance to 
check out what you sent me until now. Anyway, without further a due, "THANK 
YOU!" Seriously! that is a lot of good information! I'm checking out demo boards 

now and I hope to get started on this over the summer. The information you sent 
me will most certainly be helpful!

Thanks again!
-Jim



----- Original Message ----
From: Scott Gravenhorst <music.maker at gte.net>
To: johans121 at yahoo.com
Sent: Fri, April 22, 2011 3:29:57 PM
Subject: Re: FPGA Based Modules...

Here's a tiny bit more regarding where to start:

IMO - There's no education like hello-world projects.

I did these with LEDs and switches, with the DAC module, with a rotary encoder, 
and any other
base level device or concept.  I built up from these simple things to more 
complex collections
of simple things like numerically controlled oscillators and numerically 
controlled filters. 

This method strengthened my confidence and understanding of the ideas that would 

culminate in
a complete functional synthesizer.

Sorry for the 3 emails about this, but it's been 4 or so years since I started 
and as I
thought about "getting started" I remember things that I believe were important 
to my progress.

I do hope this all helps you.

-- ScottG
________________________________________________________________________
-- Scott Gravenhorst
-- FPGA MIDI Synthesizer Information: home1.gte.net/res0658s/FPGA_synth/
-- FatMan: home1.gte.net/res0658s/fatman/
-- NonFatMan: home1.gte.net/res0658s/electronics/
-- When the going gets tough, the tough use the command line.
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy