[sdiy] multimode matrix filter question
cheater cheater
cheater00 at gmail.com
Sat Oct 23 10:37:37 CEST 2010
Thanks for the explanation, Harry! Very helpful as usual
Cheers,
D.
On 20/10/2010, Harry Bissell <harrybissell at wowway.com> wrote:
> I'd suspect that heat would not be more of an issue than it would be
> with any other filter. If the expo conversion process (I think David is
> using the inherent expo response of the 2164 here) is temperature stable,
> the whole thing should
> track as a single unit. That leaves resistors (maybe 50ppm easy) and
> capacitors...
> you'd want good quality tight tolerance caps anyway.
>
> or would you like some Y5U ??? :^)
>
> H^) harry
>
>
>
> ----- Original Message -----
> From: cheater cheater <cheater00 at gmail.com>
> To: Dave Manley <dlmanley at sonic.net>
> Cc: synth-diy at dropmix.xs4all.nl
> Sent: Wed, 20 Oct 2010 11:08:29 -0400 (EDT)
> Subject: Re: [sdiy] multimode matrix filter question
>
> I think it could turn out to be even more sensitive to heat.
>
> But isn't that what we have epoxy resin for?? :-)
>
> Cheers,
> D.
>
> On Wed, Oct 20, 2010 at 17:03, Dave Manley <dlmanley at sonic.net> wrote:
>> On 10/20/2010 7:31 AM, David G. Dixon wrote:
>>>
>>> These are just going to be simple outputs (like any other filter). I was
>>> just wondering about what gain levels to build into the actual matrix
>>> circuit, since some of the derived filter modes are naturally much
>>> quieter
>>> than others.
>>>
>> David,
>>
>> Have you spiced the various filter modes including the gain variability
>> that
>> will be present due to component tolerances? I ran through a similar
>> exercise years ago, and the frequency response is highly sensitive to
>> component variation.
>>
>> -Dave
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
> --
> Harry Bissell & Nora Abdullah 4eva
>
More information about the Synth-diy
mailing list