[sdiy] Circuit board posts/spacers?

[dancemachine]

i used some rubber feet from my stash and screwed through a washer,
the hole in the bussboard, the rubber foot and into the wooden floor
of my synth.  when i ran out of the rubber feet i picked up a few
nylon washers from home depot and they did the trick.  i was too
impatient to order anything


On Tue, Oct 12, 2010 at 4:45 PM, ian taylor <ioddity2001 at hotmail.com> wrote:
>
> I have a couple of motm distribution boards that I need to mount inside my cab, and I want them raised an inch or so away from the surface they are going on to,
> but I don't know what the correct terminology is for the posts or spacers I need, (standoffs? risers? etc...)
> The guy in Maplins looked at me strangely and announced they don't do anything like that.
> I can't see why these aren't a pretty standard thing - can any of you tell me what to call them, or better still where I can find some? Cheers!
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>