[sdiy] sliders on panels

[Tom Arnold]

On Fri, Mar 26, 2010 at 01:08:54AM +0100, cheater cheater wrote:
> It really depends on your requirements for serviceability. Mixer
> faders are different from synth faders in that they get a LOT more use
> in a studio. The reason that the screws show on many high-quality
> mixers is that this way it's easy to hinge the front plate and unscrew
> the fader to clean it out or replace without mucking around too much.

Thats a really good point.  Well, if there are already holes in the mixer
panel for original sliders and you were just making a mounting plate to fit
in your new sliders, I'd say that'd be a good call for the subframe vs
drilling new holes.  Slight bit more work vs aesthetics.
But, yeah, I'd say 99.99% of Klee sequencers were not built with the concept
of servicablity as a major concern... :-)

-- 
 -----------------------------------------------------------------
 - Tom Arnold       -  Free Synth DIY webspace http://www.sdiy.org 
 - SynthGeek        -
 - BBD Fanatic      -  "...is it a virus, a drug, or a religion?" 
 - echo evho wjxo   -    Juanita Shrugs. "What's the difference?" 
 --------------------