[sdiy] roland tr606 clock issues

[Graham Atkins]

I'm sure someone had a similar problem a while back. As many of the  
switches
are multi-function depending on if you are pattern writing etc they  
are probably
encoded in some way, the LED will show the status depending on mode.  
Could
be a logic fault. Need to see the circuit.

Graham

On 15 Jun 2010, at 06:10, Travis Thatcher wrote:

> I checked my cable, and all 5 pins are connected.  I'm going to guess
> its a bad transistor somewhere or perhaps a bad chip? any ideas? like
> I said, the start/stop button will turn the led on and off, but not
> start and stop the pattern. i check the ribbon cables and the wires
> running from the switch board to the main one and they seem fine.
>
> -Travis
>
> On Mon, Jun 14, 2010 at 9:36 AM, Travis Thatcher  
> <recompas at gmail.com> wrote:
>> I completely forgot about that! i need to check my cable to make sure
>> all 5 pins are wired.  still, doesn't solve the clock problems of the
>> device running on its own.