[sdiy] minimoog board update

[David Griffith]

I think I'm ready to start laying out the foil patterns for the minimoog's 
power supply board.  I've already found one possible error where +10V is 
supposedly coming from pin 1 on the edge connector, but this conflicts 
with the output of the modulation mix amplifier.  I guess it should be pin 
11.

What else should I look for?  PNGs of my work are available at 
http://661.org/minimoog/.  Other questions: What are the board's exact 
dimensions?  Is there enough room to use radial-mounted electrolytic 
capacitors?


-- 
David Griffith
dgriffi at cs.csubak.edu