[sdiy] cloning minimoog boards

[Bryce Lanham]

Those are AMP Duo-Tyne card edge connectors. A bit of google searching
will get you a datasheet, though perhaps not the best one. If you can
wait until monday I can try to copy it from the giant AMP databook I
have at work. The best place I have found for the card edge connectors
is State Electronics, though those alone will probably run around $100
after minimum quantities are taken into account.

The dimensions themselves are on-list, search the archive and you
should be able to find them. If not, I'll dig them up and post them.

Bryce Lanham

On 7/16/10, David Griffith <dgriffi at cs.csubak.edu> wrote:
>
>  I think I've identified all my sources for parts.  Now comes dealing with
> the actual circuitry.  A few people stated that it would be best to
> replicate the boards exactly so as to provide people who already have
> Minimoogs with replacement boards.  The power supply board appears to be the
> simplest, so I'll start there.  My one exception for sourcing parts is in
> the card sockets.  I don't know the correct pitch for these.  Is there
> someone out there with a Minimoog who'd be willing to work with me getting
> dimensions right?
>
>
>  --
>  David Griffith
>  dgriffi at cs.csubak.edu
>  _______________________________________________
>  Synth-diy mailing list
>  Synth-diy at dropmix.xs4all.nl
>  http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>