[sdiy] ARP AXXE (gold version) fronts anyone?

[Cary Roberts]

I have a bit of experience with polycarbonate overlays but I don't own an
Axxe (nor any ARPs except for 2600s).  Looking at some pictures on the net
the front panel looks to be 22"x6" so with two color printing it'd probably
run around $50 each in low quantities done stateside.  Without artwork and a
cut layer documented I can't get a quote.  Cost is dictated by the CNC
cutter and less so the actual complexity of the artwork.

-Cary



-----Original Message-----
From: Bob Weigel [mailto:sounddoctorin at imt.net] 
Sent: Wednesday, February 24, 2010 5:50 PM
To: Cary Roberts; synthdiy
Subject: Re: [sdiy] ARP AXXE (gold version) fronts anyone?

Was thinking of just doing a plastic or vinyl overlay 
actually...figuring if we get a good looking one it would at least make 
a lot of these old difficult to use machines useful again.  Aluminum 
would probably be more than we'd want to do since the machines 
themselves are only worth 500 or so when they're in good shape. -Bob