[sdiy] Reflow revisited and a bit OT, sorry

[Graham Atkins]

I'm at the limit of my experience here but is it possible to re-solder  
these with a hot
air workstation ?.

Graham

On 29 Aug 2010, at 00:14, David Ingebretsen wrote:

> The board is densely populated with standard SMD but also the type  
> where the
> pads are underneath the chip and so are inaccessible to an iron. I  
> think it
> will require a full reflow.
>
> Understand, if it fries, it's ok since it was a freebie from a friend.
>
> I'll have a look at YouTube. Thanks
>
> David