[sdiy] Lazertran ROCKS!!

[David G. Dixon]

> > The brown stains are the burnt remnants of the Lazertran
> > gumming.  After you
> > put the decal down and squeegee it, simply run it under
> > cold tapwater and
> > rub it with your fingertips to remove that stuff.  If
> > you don't remove it
> > all, then it's easy to get off after you've cooked it.
> 
> Are you sure about this? I get stains on the cases at places that aren't
> in any contact with the Lazertran.

I'm sure about removing it before you bake it, which was very easy for me.
I simply rubbed it all over with my fingertip under the tap until it didn't
feel sticky at all.  Concerning removal after cooking, I'm going by the
instructions, which say that IPO works well.

Some people here (and on the parallel MW thread) have mentioned that they
removed the toner with the IPO after baking, but I can't see how this is
possible, since the toner is underneath the plastic coating.  Perhaps the
baking was attempted too quickly.  Everyone says that slowly raising the
temperature over a 2-3 hour period is best, and I can attest that it worked
extremely well for me.