[sdiy] minimoog board dimensions

[JR]

Hi David,

I don't have any actual regulator or rectifier boards, but utilizing
this photo of the regulator board:

http://www.fantasyjackpalance.com/fjp/sound/synth/002/mini-board-3-1.jpg

...and some known dimensions for a couple of the components on the
board, I came up with a size of

169.97mm X 108.79mm for the main part of the board, and the fingers
would be 6.22mm tall by 79.08mm wide, offset from the left edge by
30.41mm.

I'll be anxious to hear what the actual dimensions you receive from
someone else are, since it will help validate or invalidate the photo
projection method I used.  I may redo a couple of my boards to bring
them together (instead of separating everything by circuit), and I'd
like to be exact as well.

What would be really interesting would be for someone to take all the
boards, lay them out in their exact original design, and then combine
those separate boards into a single board that could be fabricated on
demand and then cut to form the originals (to keep the cost low).

--Joe R.

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------




On Sat, Jul 31, 2010 at 10:31 PM, David Griffith <dgriffi at cs.csubak.edu> wrote:
>
> I'm about halfway done laying out the power and rectifier minimoog boards.
> Does anyone have measurements of the boards they can send me?
>
> --
> David Griffith
> dgriffi at cs.csubak.edu
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>