[sdiy] ARP Axxe front panel ready

[cheater cheater]

Confusion!!!

What's going on?

:-)


Cheers..
D.

On Thu, Apr 22, 2010 at 07:40, Bob Weigel <sounddoctorin at imt.net> wrote:
> Wow that looks awesome!  I haven't done the glow in the dark one yet but the
> stock looking one is just fabulous.  I couldn't have imagined any better
> quality.  It's on a unit and ready to go.
>
> I'm pretty sure the fading is really a result of the bad FOAM episode.  I
> got a case that has the foam out of it with that one.  My other one probably
> suffered similar problems. I talked to another tech who had one with the
> same issue.  These panels are just the right thickness to make it so  you
> don't rub the slider caps at the bottom.  Any thicker and there would be
> trouble there.  The switch and trim cover popped right in.  I had to narrow
> it a hair though. (.02 or so on each end) because the one I precisely
> measured (the one slated for a glow in the dark one) is that much wider.
>  Great.  So ...what would you guys do? Have them manufactured too wide and
> let people trime them as needed on a sander (and potentially screw up the
> 100 or whatever dollar panel?) or pre cut them and let there be a .020 gap
> on each side on some units?   Who knows they might even vary more than that
> since we've only tried it on a couple here so far. -Bob
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>