[sdiy] First PCB....

[Mark Rivera]

Nice work keeping the connectors on the card edge.

I would scoot C1 to the left. The trace to its left would go under it.
That would put the ground pin of C1 out in the open, and you could
eliminate the vias/jumperwire going over the trace from C6 to C10.

Possibly one word of advice - let your design sit overnight and then
come back to it for a thorough review before considering it ready to
be ordered/made. I've run into cases where I get too used to looking
at a layout and miss something important..


On Thu, Sep 10, 2009 at 3:44 PM, Tom Adam <tom.adam at thebigear.be> wrote:
> Howdy,
> I just designed my first PCB in an effort to get to know the software
> (expressPCB/SCH). Nothing fancy, and if I would build it I would use MUUB
> pcb's, but I needed something easy for my first try.
> You can download the files here....
> www.thebigear.be/SDIY/Test2.pdf
> www.thebigear.be/SDIY/test2.pcb
> www.thebigear.be/SDIY/test2.sch
> (J4&J7 are bicoloured LED's...)
> All comments appreciated.
> Be gentle on the n00b;-)
> Cheers,
>
> --
> ToAd
> Tom.Adam at thebigear.be
> www.thebigear.be
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>