[sdiy] Vactrols and contact mics

[Tom Bugs]

Thomas Henry's Electronic Drum Cookbook is a great source of info for you!
Brought to you by the wonderful MagicSmoke.
Go to www.lulu.com and search for Thomas Henry.
Available printed or PDF download.
While you're at it grab his other cookbooks too!

cheater cheater wrote:
> Bear in mind that LEDs are not voltage-dependent in their visible
> light output (they are in their heat output!)
> A release envelope would be the same as a hold envelope. With a linear
> release, the LED would be on for say 15% of the release time and would
> turn off right after that point. With an exp envelope, the time would
> be less. What you need is a duty cycle driver.
>
> D.
>
> On Wed, Oct 14, 2009 at 10:48 PM, Byron G. Jacquot <thescum at surfree.com> wrote:
>   
>>> I'm curious if anyone has experience with driving the LED of a vactrol
>>> with a contact mic.  The contact mic would be attached to a drum so
>>> I'm guessing the voltage would be high enough to light the LED but
>>> would it be very instantaneous or perhaps it needs to be amplified?
>>> Would it be simple to create some sort of decay?  Ultimately I would
>>> like to be able to trigger a voltage controlled dimmer connected to an
>>> incandescent bulb with a drum.
>>>       
>> Piezos are not very well behaved...you need to protect any following circuitry from possibly very large spikes, and maybe filer out the self resonance.  Thankfully, it can be broken up into a series of sequential stages, see the following link for some ideas:
>>
>> http://leucos.lstilde.org/wp/2009/06/piezo-transducer-signal-conditioning/
>>
>> Than you might follow that with a comparator to square up the pulse, and feed it into a standard AR envelope, with the A time constant set very fast.
>>
>> Byron Jacquot
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
>>     
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.421 / Virus Database: 270.14.18/2437 - Release Date: 10/15/09 03:57:00
>
>