[sdiy] Laser etching powder coated aluminum

[Simon Brouwer]

Hi Cary,

Can you provide some details of the laser you used?

Best,
Simon


Cary Roberts schreef:
> A sample of laser etched powder coated aluminum I did for an instructor at
> Techshop.  Forgive the slightly blurry photos - the actual part was
> crystal
> clear.  I'd say it works every bit as good as engraving anodized aluminum.
> One should probably put a coat of clear powder coat on the work piece
> after
> engraving to ensure the clear areas don't oxidize unevenly.
>
> 	http://www.flickr.com/photos/79234330@N00/sets/72157622903590264/
>
> -Cary
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>


-- 
Vriendelijke groet,

Simon Brouwer
-*- nl.openoffice.org -*- http://www.opentaal.org -*-