[sdiy] Question about modular bi-polar power rails

[Suit & Tie Guy]

On Nov 13, 2009, at 11:49 AM, Altitude wrote:
> I am in the process of tricking out my WTPA sampler with a yusynth  
> Arp LP
> filter clone and was wondering if I can power it with +/- 12  
> instead of +/-
> 15.  The sampler runs of a 5v regulator and 10V is a lot of voltage  
> to burn
> off as heat.


that circuit runs just james dandy off of 12 volt rails. in fact, you  
can calibrate it at 15v, put it on 12v, and it still tracks the same.
---
Suit & Tie Guy
suitandtieguy.com
stgsoundlabs.com