[sdiy] tiny pcbs?

[Seb Francis]

I would think that a Dremel is going to find PCB material hard work.  
Plus would probably produce very fine dust.

Best thing I've found for DIY cutting of PCBs is a sharp jigsaw blade, 
designed for metal (very fine teeth).  It won't be sharp by the time 
you've finished!  My jigsaw has a plastic plate that clips on the bottom 
to prevent scratching.  Otherwise, best to protect the PCB somehow 
(masking tape?)

Seb


cheater cheater wrote:
> Might even be able to skip the groove and just Dremel(tm) it all yourself.
>
> D.
>
> On Sun, Nov 1, 2009 at 07:52, Paul Perry <pfperry at melbpc.org.au> wrote:
>   
>> Danjel, if you need a quantity (say 4 or more)
>> you can do a number beside each other & get
>> a groove milled between them so you can snap them
>> apart.
>>
>> paul perry Melbourne Australia
>>
>> ----- Original Message ----- From: "Danjel van Tijn"
>>
>>     
>>> I am looking for a pcb fab house that can make 2 layer boards that are
>>> really narrow in width (10mm wide and 20mm wide).
>>> Most of the places I checked have a minimum of about 1".
>>>
>>> cheers,
>>> Danjel
>>> _______________________________________________
>>> Synth-diy mailing list
>>> Synth-diy at dropmix.xs4all.nl
>>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>>       
>> --------------------------------------------------------------------------------
>>
>>
>>
>> No virus found in this incoming message.
>> Checked by AVG - www.avg.com
>> Version: 8.5.423 / Virus Database: 270.14.40/2471 - Release Date: 10/31/09
>> 07:53:00
>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
>>     
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
>