[sdiy] Prototype wiring pen

[Scott]

Thanks everyone, I jumped in and did it last night.  Like someone else said, worse that would happen is I'd burn up some wires, but that isn't going to happen from a gate signal!
I used a pencil to hold the wire down to the panel when I made bends (instead of having a post), and routed the wire neatly around the panel which kept everything somewhat tidy.  Then when all of my wires were complete, I glued down those corners, and a few other places along the vero-wire.
Fast and easy!  I was daisy-chaining between a bunch of parts, which is why I wanted to use this, instead of having to snip wires and make a bunch of double solders, etc...

If it causes any trouble down the road, I'll certainly write back.

Scott