[sdiy] converting a 10v p to p to a 0-5 volt signal

Dan Snazelle subjectivity at hotmail.com
Wed May 20 02:30:36 CEST 2009



tonight i was looking at my scope

Checking the input into a circuit that was only able to take 0-5 volts

Sure enough, the signal was between 0 and 5 but the sawtooth was clipped.

So i am looking for a input block that can take either
5vp to p or 10v p to p (or any synth signal)
and spit it out as a 0-5 signal without squaring the top.


anyone know of a good circuit for this?

thanks




More information about the Synth-diy mailing list