[sdiy] Board manufacturing questions

David Ingebretsen dingebre at 3dphysics.net
Mon May 18 03:20:54 CEST 2009

Thank you. Turns out, they have a US office in San Jose California.


I purchased Target 3001! for layout and they take a Target file directly
which I thought was convenient.

Thanks Monty.


-----Original Message-----
From: synth-diy-bounces at dropmix.xs4all.nl
[mailto:synth-diy-bounces at dropmix.xs4all.nl] On Behalf Of mcb, inc.
Sent: Sunday, May 17, 2009 6:06 PM
To: 'Synth-DIY DIY'
Subject: RE: [sdiy] Board manufacturing questions

On Sat, 16 May 2009, David Ingebretsen wrote:

> Has anyone used PCB-Pool?

I used them for a ladyada project.  Good quality, they
have automated email for major steps in the fabrication
process.  A bit pricey to use from the US but no complaints.

Monty Brandenberg
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl

More information about the Synth-diy mailing list