[sdiy] Arp Odyssey sliders cleaning/ restoration

[Dave Manley]

1. spraying deoxit will mostly move the crud around inside in the pots 
and also down onto the board, leaving residue in the pot and on the 
board.  Depending on where it ends up on the board, this could cause a 
problem.  I guess for a quick fix, you could try spraying the pot while 
holding the board upside down, so the crud flushes out the slot in the 
top of slider, away from the board.

2. there is no problem with removing the sliders and cleaning them 
separately from the board, other than the risk of damaging the pcb in 
the process (and also reassembling the board incorrectly!).

-Dave

Karl Ekdahl wrote:
> So
> 
> I was wondering if there's any less intricate way of doing this, i mean what if you were just to spray some deoxit in them and grease them? Would that just make for future clogging? How about just washing the sliders with simplegreen instead of the whole boards?
> 
> Karl
> 
> --- Den tors 2009-04-30 skrev jeff brown <guitaricon at verizon.net>:
>