[sdiy] making panels with metalphoto?

[Tom Arnold]

On Sun, Mar 08, 2009 at 05:52:35PM -0700, Danjel van Tijn wrote:
> I was wondering if anyone had experience getting short runs of panels
> made (e.g. 1-4 at a time) and had found the cheapest place to get the
> panels made and cut (metalphoto and cnc cutting)?

I havent found any place to do small runs of Metalphoto will full
processing.  Did find a few that would run a one-off panel for me but I had
to do all cutting/drilling.

I personally use ID-Mark and I'm sure if I talk about it too much I will get
lynched cause I always mention it.  Check the archives.

You might also want to check with stg/soundlabs, he uses metalphoto and
might have some suggestions for you.

-- 
 -----------------------------------------------------------------
 - Tom Arnold       -  Free Synth DIY webspace http://www.sdiy.org 
 - SynthGeek        -
 - BBD Fanatic      -  "...is it a virus, a drug, or a religion?" 
 - echo evho wjxo   -    Juanita Shrugs. "What's the difference?" 
 --------------------