[sdiy] source for many, small, simple PCB's ?? for educational use

[Derek Holzer]

Hi Tony,

how is PCB Cart, or PCB houses in general, about replacing boards where 
there are such obvious errors? Or do you just over-order by a certain 
percentage and hope that you get the run you need in the end?

D.

Tony Rolando wrote:
> I have used PCB Cart alot. The customer service is great and the price 
> is, as all things from China, lower then one would expect. HOWEVER, I 
> would say the quality is just OK. I have had many boards where the 
> soldermask or silkscreen is offset and covers portion of the pads, or is 
> spotty (characters not legible). I have also had depanelization where a 
> good chunk of the board is cut off, I have even lost pads this way (with 
> all traces, pads well within accepted limits of PCBCart).

-- 
derek holzer ::: http://www.umatic.nl ::: http://blog.myspace.com/macumbista
---Oblique Strategy # 157:
"Think
- inside the work
- outside the work"