[sdiy] source for many, small, simple PCB's ?? for educational use

[Seb Francis]

(Amongst other things) I run a small business manufacturing/selling 
psychometric measuring devices.  We tend to get a couple of hundred 
small boards made at a time and have always used European manufacturers 
until recently when we tried PCB Cart.  We were most impressed by the 
quality and customer service, to say nothing of their willingness to be 
'creative' with declaring the order value for customs.  And was 
significantly cheaper than any European suppliers ...

http://www.pcbcart.com

Seb


Steve Maietta wrote:
> All,
>   I teach HS level technology here in the US and do a unit on electricity/electronics.  I want to get a whole bunch (200 perhaps) small(around 2"x2") PCB's made and would like to know the cheapest source.  Single sided, no solder mask, no through plating - whatever it takes to keep the cost down.
> These would be general purpose boards for 555's and include small area for other components.  I might also want to do a similar thing for an op amp.
> I know I could etch myself a lot of them, but the drilling would be a killer, and I want my students to have sucessful projects, not learn the intricacies of drilling with .030 drill bits...
>
> I know you guys have used lots of places for your projects.. Any suggestions/ideas for cheap PCB fab?   Or should I just use perfboard..?
>
> thanks
> ~Steve
>
>
>       
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
>