[sdiy] Mounting hole size for switch - can't seem to get from datasheet

[Graham Atkins]

Just having a Google, 0.75mm is the thread pitch used for the Metric  
Fine
system as opposed to 1.00mm for standard metric threads :-

http://mdmetric.com/tech/thddat3.htm

Graham

On 30 Jun 2009, at 19:57, Justin Owen wrote:

> From: Danjel van Tijn [danjel at gmail.com]
>
>> whoops I was being dumb. 5.25mm is only if you plan to tap the hole.
>> M6 is a 6mm hole (The '6' is for the size in mm)
>
> 0.75mm might refer to the thickness of the supplied hex nut.
>
> ...I could be wrong though.
>
> Justin
>
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>