[sdiy] Talking of panels.... (was: Small drill pressrecommendations)

[Julian]

> Just discard this whole thread,
>
> Steve Thomas just promised me to cut anything on anodized aluminum he
> provides.. minus -5% per panel that Julian thinks he can offer! And
> any Pot holes, You Know are cut to fit!
>
> Samppa


Samppa,

See, if it were just between you and I, I wouldn't bother replying to your 
(i hope obvious) troll, but as you saw fit to post publicly....

You evidently missed my earlier post naming and thanking the person who gave 
me so much assistance in building this machine, over numerous cups of tea, 
not to mention 100s of emails?

However, even if you had have seen that post, what you couldn't have know in 
your pathetic baiting that you are so famous for, was that Steve generously 
gave me his remaining 5u panels when he quit engraving for all but his 
oldest clients.  Comically, the photos on my site are of this very material.

Anyway, undoubtedly you will expend effort in trolling me further.  The 
thing is, I realise that my days in this realm are numbered and that there 
are nicer ways to spend them than with you : )


Samppa, to be clear -

This will be my last communication with you, private or otherwise.