[sdiy] using 6264 Ram

[Dan Snazelle]

ok

i am understand this a lot better now.
however

the fact that the I/O pins are reading or writing depending on the state makes it a bit more complicated.

i should really try to find a schematic that uses this chip or something similar so I can see how to route the signal to be stored and the signal to be read or heard

i am assuming i cant just hook both up to the same pin...

can anyone recommend a schematic that uses SRAM chips?

thanks so much




----------------------------------------
> From: synth1 at airmail.net
> To: synth1 at airmail.net; synth-diy at dropmix.xs4all.nl
> Subject: Re: [sdiy] using 6264 Ram
> Date: Tue, 16 Jun 2009 09:58:00 -0500
> CC:
>
>> d) There is probably a /WE (Write Enable, active low) or sometimes it's
>> called R/~W (Read/not WRITE) which is an input that tells the chip if you
>> want to READ to WRITE
>>
>
>
> Errr...that should say READ (logic '1') or WRITE (logic '0').
>
> Paul S.
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy