[sdiy] PPG EVU info?

[Paul Maddox]

Mark,

   :-)
The EVU is basically a wave 2.3, whilst the difference in number is  
small, the insides are VERY different.
The 2.3 is 12 bit, 8 part multi-timbral and the PROZ board is very  
different to the 2.2, which is 8 bit and mono-timbral (ok, bi  
trimbral, but....).

check here for more detail ;-
http://www.ppg.synth.net/wave23/

I have *SOME* schematics for the 2.3, but not all, specifically *NOT*  
the proz board, more detail of the proz board can be had here - http://www.ppg.synth.net/faq/proz_fault.shtml

If you want more, mail me off list.

Paul


On 15 Jun 2009, at 18:47, mark verbos wrote:

> I have a PPG EVU on my table. I was only adding the MIDI interface,  
> but it doesn't seem to be working at all. Does anyone have  
> schematics or other info on this? All I have is Wave 2.2 stuff, but  
> it's confusing trying to figure out from that. Thanks in advance.
>
>
> Mark
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy