[sdiy] eurorack tapped strip (in M3) source pref. uk?

[Stewart Pye]

Samppa,

There is more than language to be watched here.
I really didn't want to get involved in this, however I emailed you 
privately and asked nicely that you don't attack other list members yet 
you are still doing it. If you disagree with someone then just disagree 
and leave it at that. There is no need to continually publicly attack 
them for no valid reason.

Surely there is a forum on the web somewhere where members put each 
other down and rant incoherently. Perhaps you could join that. This is 
not the place for it. We have common interests here and are supposed to 
be friends. It's ok to disagree, but not to put others down.

Sorry to list members for the public post. I just had to get it out, and 
I won't continue this discussion.

Regards,
Stewart.


David Ingebretsen wrote:
> Watch your language children, please :)
>
> David
>
> David M. Ingebretsen M.S., M.E.
> Collision Forensics & Engineering, Inc.
> 2469 East Fort Union Blvd. STE 114
> Salt Lake City, UT 84121
> www.CFandE.com
>
> 801 733-5458 Office
> 801 842-5451 Cell
>
> dingebre at CFandE.com
> dingebre at 3dphysics.net
>
> ~~ 
> ~~ Who Really Gives A Flying **** about Your Strips?
> ~~ 
> ~~ If http://www.metaloffcuts.co.uk/ does 3 panels of 820mm width at
> ~~ £115, You sure Shouldn't be worried about any customers?
> ~~ 
> ~~ Samppa
> ~~ 
> ~~ _______________________________________________
> ~~ Synth-diy mailing list
> ~~ Synth-diy at dropmix.xs4all.nl
> ~~ http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>