[sdiy] For breadboard lovers...

[Jason Tribbeck]

Hi,


>> you can etch your own boards with that fine pitch? I would be
impressed....
>
> I etched boards on my own with downto 0.5mm pitch.
> I work with "DIY films" from laser printers - I stack two films for
higher
> contrast.
> 
> No problems!

0.5mm's also no problem for me using an inkjet and a single OHP sheet.
It isn't even opaque, but it's good enough for etching, and pretty cheap
too.

With my earlier printer, I used to run it twice to get the density (I
hadn't thought about using two sheets). The registration was generally
good, but occasionally it would be off.
-- 
Jason Tribbeck