[sdiy] Weird Serge front panel overlap material

[Chris Muir]

I've seen one DO NOT REMOVE that seemed to be Tyvek. I'd go check,  
except, rebel that I am, I removed it.

- C

On Jul 8, 2009, at 2:20 AM, mark verbos wrote:

> Is that what the "do not remove" labels on mattresses are made of?
>
>
>
>
> On Jul 8, 2009, at 5:05 AM, Louis van Dompselaar wrote:
>
>> Could it possibly be Pertinax (FR2)?  So a paper/resin composite.
>>
>> http://en.wikipedia.org/wiki/FR-2
>>
>>
>> Op 8 jul 2009, om 08:53 heeft Aaron Lanterman het volgende  
>> geschreven:
>>
>>> While we're talking about front panels - I took a closer look at  
>>> the overlay on my little kit-built Serge.
>>>
>>> I can't figure out what it's made of. It's like a thick paper, but  
>>> it doesn't seem to want to tear like paper (not that I really  
>>> tried very hard). It looks like metal but it's not hard like  
>>> metal. It's peeling off on one corner, so it's quasi-flexible.
>>>
>>> Anyone knowledgeable about Serge stuff out there know what this is?
>>>
>>> Whatever it is I doubt it could be run through a printer, sadly -  
>>> it seems too stiff. Otherwise, it seems like it would be a nice  
>>> option for doing overlays over standard panels (like Ray Wilson's  
>>> universal panel, or John Blacet's DIY panel, or whatever), if I  
>>> can figure out what it is.
>>>
>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>

Chris Muir
cbm at well.com	
http://www.xfade.com