[sdiy] Connecting two boards

[Tom Arnold]

On Tue, Jul 07, 2009 at 04:15:41PM -0600, Byron G. Jacquot wrote:
> Look into IDC (inslation displacement, AKA ribbon cable) connectors.  Dual row on .1" centers, available in a fair variety of straight & right angle combinations.  While they're usually intended to be used with a ribbon in between, you can also mix & match the PCB ends, and probably reach the combination you need.
>

This is exactly the tyoe of connector I've been looking for, however, they
dont seem to readily exist in the form I'm looking for.  There seem to be
some available options in the 1mm and 2mm spacing, but not .100" 2.54mm
spacing which I require.

It seems strange that this isn't readily available from multiple sources.
I'm hoping I'm just missing them.  I actually read page-by-page the
interconnect section of the mouser catalog with no luck...

-- 
 -----------------------------------------------------------------
 - Tom Arnold       -  Free Synth DIY webspace http://www.sdiy.org 
 - SynthGeek        -
 - BBD Fanatic      -  "...is it a virus, a drug, or a religion?" 
 - echo evho wjxo   -    Juanita Shrugs. "What's the difference?" 
 --------------------