[sdiy] Tolerances for front panels

Kevin Haywood fetafarmer at fetafarm.com
Wed Jul 8 08:20:08 CEST 2009


I've always used these standard dimensions, and have never had a  
problem with panels fitting next to each other.

Cheers,
Kevin


On Jul 7, 2009, at 8:08 AM, Aaron Lanterman wrote:

> A standard frac rack front panel is 5.25" by 1.5", 3", or 4.5".
>
> When putting those #s in FPE, to make sure my panels will actually  
> fit next to each other, should I be shaving a tiny amount off that,  
> and if so how much?
>
> - Aaron, the mechanically uninclined
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy



More information about the Synth-diy mailing list