[sdiy] Eagle

[Csaba Zvekan]

Hi Paul ,

Sometimes you would a part but the net connections are not made .  
Meaning they are not connected . So it ignore the part in the board  
layout. Check your green wire again . Sometimes they look connected :)

Csaba

On Jan 19, 2009, at 12:14 AM, Paul Maddox wrote:

> Peter,
>
> I'm confused, both PCB and Schematic are open, if I open the project  
> they both open, one is minimized.
>
> but nothing appears on the PCB (I've added one component).
>
> Paul
>
> On 18 Jan 2009, at 21:07, Ullrich Peter wrote:
>
>> Hi Paul!
>>
>> To have the layout and schematics up to date you need to open both  
>> the schematics AND layout when starting your session.
>> Otherwise you only change the schematics and there will be no  
>> annotation to the layout. Normally Eagle tells you that this could  
>> happen if you don't open the other too.
>> At least if you only open the layout and change something there  
>> will be a warning.
>>
>> So the safest solution is starting again from your old edition -  
>> open the layout and then add the changes again.
>> Maybe a lot of work (depends on your changes)  but it works - you  
>> can see each change will be done also in the layout.
>>
>> Ciao
>> Peter
>>
>> ________________________________________
>> Von: synth-diy-bounces at dropmix.xs4all.nl [synth-diy-bounces at dropmix.xs4all.nl 
>> ] im Auftrag von Paul Maddox [paul.maddox.mail-list at synth.net]
>> Gesendet: Sonntag, 18. Jänner 2009 21:43
>> An: Synth DIY
>> Betreff: [sdiy] Eagle
>>
>> Guys (and girls),
>>
>>  I've made a change to my schematic in Eagle, but how do I update
>> the board layout to reflect these changes? Obviously I need to rip up
>> the routing, (that I can do), but what do I do after that?
>>
>> Paul
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy